These MICHELIN® tires carry a limited warranty in addition to the standard materials and workmanship warranty for treadwear or mileage.
- Available on: Energy™ Saver A/S
- Speed Rating: V
Our ultimate fuel-efficient passenger car tire is ideally suited for drivers looking to maximize fuel economy without compromising long treadlife and all season safety.
*Mileage Warranty Exceptions
Split fitments – If your vehicle has tires of different sizes on the front versus the rear axles, your tires cannot be rotated as recommended. Therefore, the mileage warranty on each rear tire will cover half the number of miles as the standard mileage warranty for that particular tire line. ZP (Zero Pressure) tires – The maximum mileage warranty for ZP tires is 30,000 miles.
Select your Year
Section Width on Measuring Rim Width
7.00" on 5.00"
Max Load, Single (LB @ PSI)
1102 @ 44
Rim Width Range (Min/Max)
Tread Depth (in 32nds)
MICHELIN® Energy Saver A/S Fuel Efficient Tires - Why Choose MICHELIN® Tires
**Based upon rolling resistance testing versus Bridgestone® Turanza® EL400, P185/65R15 size tire. Fuel savings are estimates only. Actual on-road savings may vary.
***Based on third-party wear test results versus Bridgestone® Ecopia EP100, P185/65R15 size tire .
****Based on internal wet braking test results versus Bridgestone® Ecopia EP100, P185/65R15 size tire .
*Based on third party wet braking test results versus Bridgestone® Ecopia EP100, P185/65R15 size tires.
OE Code [Original Equipment Key]: FOR = Ford, CHR = Chrysler, HON = Honda, TOY = Toyota, NIS = Nissan, GM = General Motors, HYN = Hyundai, KIA = Kia
>> The sizes shown are average design values for tires measured on specified measuring rim widths. Some tires may vary from this value by +/-3% of the section height (affecting overall diameter), and +/-4% of the section width.
>> Section width varies approximately 0.2" (5mm) for every 0.5" change in rim width.
>> Tread patterns are often tuned to accomodate different tire widths. Tires for a particular dimension of a given tireline may vary in appearance from the tire shown in the photograph.
WARNING: Serious or fatal injury may result from tire failure due to underinflation or overloading. To ensure correct air pressure and vehicle load, refer to vehicle owner's manual or tire information placard on the vehicle. Serious injury or death may result from explosion of tire/rim assembly due to improper mounting. Only tire professionals should mount tires and they should never inflate beyond 40 psi to seat the beads. Before mixing types of tires in any configuration on any vehicle, be sure to check the vehicle owner's manual for its recommendations.
DANGER: Never mount a 16" diameter tire on a 16.5" rim.
Inflation pressure increase must not exceed the maximum pressure branded on the tire sidewall. When a customer requests a replacement tire with a lower speed rating than the original equipment tire, you must clearly communicate to him or her that the handling of the vehicle may be different, and that its maximum speed capability is limited to that of the lowest speed-rated tire on the vehicle. Exceeding the lawful speed limit is neither recommended nor endorsed.
For high-speed driving, additional inflation pressure and possibly reduced tire loading and/or upsizing is required. In the absence of specific recommendations by the vehicle manufacturer, use the following guidelines based on those in the European Tyre and Rim Technical Organization Standards Manual.
For speeds over 160km/h (100 mph), load and inflation must be adjusted according to the table below.
T-Speed Rated Sizes:
Maximum Speed (mph) 100 106 112 118
Inflation Increase (psi) 0.0 1.0 2.0 3.0
Load Capacity (% of max.) 100 100 100 100
V-Speed Rated Sizes:
Maximum Speed (mph) 100 106 112 118 124 130 136 143 149
Inflation Increase (psi) 0 1 2 3 4 5 5 5 5
Load Capacity (% of max) 100 100 100 100 100 100 97 94 91
8am - 7pm EST (Mon-Fri)
and 9am - 1pm EST (Sat).